Putting the RS 195 into operation
16 | RS 195
Inserting or replacing the rechargeable batteries
1 Turn the two ear pads counterclockwise until you overcome a
slight resistance.
2 Lift the ear pads off the ear cups to reveal the battery compart-
ments.
3 Insert the rechargeable batteries into the compartments. To
replace the batteries, pull the batteries out of the compartments
and insert the new ones. Observe correct polarity when inserting
the rechargeable batteries. Dispose of old rechargeable batteries
as special waste or return them to your specialist dealer.
4 Place the two ear pads back on the ear cups. Observe the L (left)
and
R (right) markings on the rear of the ear pads.
5 Turn the two ear pads clockwise until they lock into place.
You can also power the headphones using standard batteries
(AAA size, 1.5 V). Note, however, that standard batteries are not
rechargeable, and if you are using standard batteries, do not
place the headphones on the transmitter's headphone holder.
To Next Page
Loading...
