18
WEB600 User’s Manual
Pressing the Search button will rescan your network for any Sensaphone devices that may be connected.
Your specific device can be identified by using the MAC Address field of the Sensaphone Locator, which
will be identical to your serial number. Click on your device within the Sensaphone Locator application
and click the Connect button. Your web browser will launch, taking you to the Web600’s homepage.
Your Web 600 is now ready for use. Be sure to read the Network Configuration section of the manual for
further configuration options - such as configuring a static IP address.
RESETTING THE WEB600 TO FACTORY DEFAULT SETTINGS
In the event that you can no longer connect to your WEB600 or simply have forgotten the password, you
can reset the unit to factory defaults. On the bottom of the enclosure is a small hole. Beneath the hole is
a push button. Insert a paper clip or similar item into the hole and push the button for 5 seconds while
the device is powered on. The WEB600 will erase all of its programming and then reboot automatically.
To Next Page
Loading...
Need help?
General
