Quick start guide
3. Choose the file format and enter the path to the file, or click Browse and
locate the files.
4. Enter the paths to your reference station RINEX observation and navigation
files, or click Browse to locate the file on your computer.
Once complete, click Next to continue.
eMotion will carry out post processing of the raw rapid static survey GNSS data you
provided and show the result on the next screen. The degree of success depends
on a number of factors including occupation time and base line length. eMotion
will display one of the following messages below the result:
OK: Precise position obtained
The raw GNSS data could be processed and the base line length and cumulative
occupation time were sufficient to obtain a precise base position.
Warning: Position may remain imprecise
Although the raw GNSS data could be processed, the combination of base line
length and cumulated occupation time may not have been enough to obtain a
precise base position.
Failed: Position is incorrect
Although valid raw GNSS data was provided, it was unsuitable and the calculated
base position is incorrect. The reference data may have fallen outside the time
frame of your mission or come from an unsuitable reference station.
Error
eMotion could not process the raw GNSS files. They may be corrupted or in a for-
mat that eMotion cannot process, or there has been an error.
• Step 7 - Select outputs: Choose the output actions to execute and files to
create. Geotagging images is necessary to create geoinfo, KML and Post-
flight Terra 3D files.
• Step 8: You may now disconnect the drone. Eject the SD-card drive and the
66
To Next Page
Loading...
