Maintenance, Repair and Troubleshooting
10.1 Pre-flight errors
As soon as the battery is connected to the drone it performs a series of pre-flight
checks to thoroughly test its on-board systems. The start-up process is described
in detail in section ‘Preparing the eBee RTK for flight’ on page 41. If an error occurs
during these pre-flight checks the status LED will blink red and a description of
the error will appear in eMotion. In most cases, re-connecting the battery will suf-
fice to remove the error. Table 3 presents all the Pre-flight errors that may occur
and possible actions to fix the error. If the problem is related to the firmware in
the on-board autopilot, try re-loading the firmware using instructions in section
‘Updating the eBee RTK software’ on page 148. If an error persists after reconnect-
ing the battery several times we recommend you report the problem by following
the instructions in section ‘Reporting a problem with your eBee RTK’ on page 181.
Table 3: Pre-flight errors
eMotion text Description and User action
Incorrect firmware
detected
There is an error with the current version of the
firmware in the eBee RTK’s autopilot.
User action: Re-load the correct firmware⁵⁶.
Battery too low for
take-off
The battery level is too low to perform a take-off.
User action: Re-connect a fully-charged battery.
Drone flight log
memory full
The memory card used to store the Drone flight log is
full.
User action: Empty the memory card by follow-
ing the instructions in section ‘Importing images and
flight data’ on page 61.
⁵⁶ see section ‘Updating the eBee RTK software’ on page 148
158
To Next Page
Loading...
