What does 'SSd' on display with TANK light ON mean on Senztek Water Heater?
If ‘SSd’ is displayed and the TANK light is ON on your Senztek Water Heater, it could mean the wire to the Tank sensor is shorted, and you should repair the wire. Alternatively, the Tank Sensor might be damaged and need replacement.
What does 'SSd' on display with flashing INLET light mean on Senztek Water Heater?
If ‘SSd’ is displayed and the INLET light is flashing on your Senztek Water Heater, it could mean the wire to the Inlet sensor is broken, in which case you should repair the wire. If that's not the issue, the Inlet Sensor might be damaged and require replacement.
What does 'SSd' on display with INLET light ON mean on Senztek Water Heater?
If ‘SSd’ is displayed and the INLET light is ON on your Senztek Water Heater, it could indicate a shorted wire to the Inlet sensor, which you should repair. If the problem persists, the Inlet Sensor might be damaged and need replacement.
Provides essential safety guidelines for the installation and servicing of the SolaStat™.
Outlines crucial precautions for controller placement and sensor mounting for safe operation.
Details vital electrical safety measures, including wiring and power supply considerations.
Explains how to connect the SolaStat™ controller to sensors, mains, and the pump.
Details the final operational checks to perform after installation before leaving the site.
Introduces pump cavitation, its causes, and potential damage to the pump.
Details methods to prevent pump cavitation and potential solutions if it occurs.
Provides step-by-step instructions to access the installer programming mode.
Details how to set the PUMP OFF temperature threshold for optimal tank heating.
Explains how to set the PUMP ON temperature for transferring heat from the collector.
Guides on setting the maximum allowable tank temperature to prevent overheating.
Explains how to set the FROST value to protect the collector from freezing.
Details how to save programmed values and exit the programming mode.
Step-by-step instructions for replacing a damaged sensor, including enclosure access.
General| Brand | Senztek |
|---|---|
| Model | SolaStat-Plus |
| Category | Water Heater |
| Language | English |
To Next Page
