BRIEF
INSTRUCTIONS
WARNING!
Before using this
instrument, read instructions in
Section
1
concerning proper power
connections and grounding.
2-0 PRESET MODE
1. Check that PITCH
wheel is centered.
2.
Check that MOD
wheel
is
set
to
minimum
(finger-slot towards you).
3. Play. Adjust
VOLUME.
4.
Check that MASTER TUNE
knob is centered, or
tune against another
instrument for
A-440.
5. To switch
programs
(up to 99),
press any two
PROGRAM SELECT switches.
6. Use the PITCH and MOD
wheels.
7. After a few
minutes, press TUNE. Retune as needed.
For more
information,
see
Section
3.
2-1 PROGRAM EDIT AND RECORD
1. Adjust knobs and switches to
modify current program. Decimal point
between
program digits lights, indicating Edit Mode.
2. To cancel changes, re-select
program or press PRESET twice.
3. To record edited program, press
RECORD then select desired
program destination.
For more
information,
see
Section 6.
2-2
UNISON
NORMAL:
Switch
UNISON
TRACK
up.
Play.
CHORD TRACK: Hold chord. Switch
UNISON TRACK up, or press footswitch (if
already in Normal Unison).
To track a different chord, switch UNISON
TRACK
off,
then hold
new
notes,
then switch UNISON TRACK on, or
press footswitch.
For
more information, see pages
3-4
and
3-5.
CM600A 12/82
2-1
To Next Page
Loading...
