2-3 ARPEGGIATE
UP/DOWN:
Switch ARPEG UP-DN on. Hold keys.
Adjust SPEED.
ASSIGN:
Switch
ARPEG ASSIGN on. Hold keys
in the order to
be arpeggiated.
LATCH: Press RECORD
or hit footswitch.
STEP:
Turn
SPEED to
-5 (fully
counter-clockwise). Hit
footswitch quickly, since the
arpeggiator will
advance when the
footswitch is released.
EXTERNAL
CLOCK: Turn SPEED to
-5.
Connect
clock
to
footswitch jack.
For more
information, see
Section
i*.
2-4
SEQUENCER
RECORD:
Switch RECORD on.
Select SEQ I or SEQ
2. Play. To stop recording, press
footswitch or
RECORD. Sequence will
playback. To stop, press
SEQ 1 or 2 again, or
press
footswitch.
PLAY: Press SEQ
1 or SEQ 2. To stop,
press again, or
press footswitch.
PROGRAM
SPEED: During playback, adjust
SPEED knob as desired.
To program speed,
press RECORD.
For more
information, see Section
5.
2-5
SAVE TO
TAPE
1. Insert tape and
rewind
to
start.
2. Press RECORD.
3. If
storing only ten
programs, press appropriate
PROGRAM SELECT once,
so
the
second display digit is
blank.
k. Start
recorder in record mode, with
level
"at
"0,"
or slightly into the red.
5. Press
TO TAPE.
6. If
storing sequences,
press either SEQ I or 2
(within
3
seconds of TO TAPE).
7. When FROM
TAPE blinks, stop recorder
and rewind.
8. To verify, start
playback.
9. Press the FROM TAPE
switch.
10. When the FROM
TAPE
LED
goes out, stop the
recorder. The file has been recorded
and
verified.
For more
information, see Section 8.
2-2
CM600A 12/82
To Next Page
Loading...
