Sequoia LISST-200X - Page 54

LISST-200X User’s Manual LISST-200X Operation Details Page 46
5
• The battery pack can be connected to the LISST-200X
using the provided 5-pin Male to 5-pin Female cable.
• Connect the Male end of the cable to the Female
Bulkhead connector on the Small Battery Pack.
• Connect the other end of the cable to the 5-pin Male
bulkhead on the LISST-200X.
• Power is now going to the LISST-200X. If AutoStart is
enabled the instrument may be looking for the start
condition.
Instrument is powered
and ready to collect
data
6
• If desired connect the Communications cable to the
male 5-pin bulkhead connector on the Small Battery
Pack. Communications will pass through the battery
to the LISST-200X.
• The battery and communications cables are shown
below.