Sercel GRC ESP-Series - Appendix; Surface Readout Status Message Summary

Doc No. 006-0211-00 Rev AD Page 57 of 62
APPENDIX
Surface Readout Status Message Summary
Status Messages
Message
Description
SPS Idle
Run Mode Disabled
SPS SncPhs 1
Applying Voltage
SPS SncPhs 2
Initial Current Check
SPS SncPhs 3
Detecting 1
st
Signal Transition
SPS SncPhs 4
Measuring Tool Signal
SPS SncPhs 5
Wait for End of Sync Phase
SPS Power Off
Gauge Power Off
SPS Init EE
Initialization
Rcv Hdr nn
Receiving Tool Header
Rcv Dat mm
Receiving Tool Data
Analyze 1-16
Analyzer
Config Coils
Initialization
Driving HighV
Safe Volt Disabled and Driving Imbalance