Doc No. 006-0211-00 Rev AD Page 44 of 62
Updating SPS-1500 Using Tera Term - TTermpro
1. Open TTERMPRO
2. Select SERIAL BUTTON
3. Drop down box and select USB SERIAL PORT and COM PORT NUMBER
found under CONTROL PANEL/DEVICE MANAGER/PORTS.
4. OK
5. SETUP MENU then SERIAL PORT. See Figure 39.
a. PORT: Select Com Port
b. Baud Rate: 9600
c. DATA: 8 Bit
d. PARITY: NONE
e. STOP: 1 BIT
f. FLOW CONTROL: NONE
6. Select OK
Figure 39 TTERMPRO Serial Port Setup.
7. Depress SHIFT-U while powering up the SPS-1500. You should see the screen
in Figure 40.
To Next Page
Loading...
