Sercel GRC Spy Pro - User Manual

1
a
Field
Installation
Manual
ESP
MONITORING
SYSTEMS

Sercel GRC Spy Pro Specifications

General

Weight	1.5 kg
Operating Temperature	-20°C to +70°C
Power Source	Internal battery
Data Storage	Internal memory
Power Supply	Internal battery
Sample Rate	Up to 4000 Hz
Sampling Rate	Up to 4000 Hz

Summary

Bench Testing and Verification Procedures

Process Steps for Bench Test and Verification

Outlines the steps for performing bench tests and verification.

Process Steps for Insulation Test with Megger Tester

Details steps for insulation testing using a Megger tester.

Process Steps for Resistance Test with Analog Type Meter

Details steps for resistance testing using an analog multimeter.

Installation Procedures for Downhole Gauge

Installing the ESP Sensor with WYE Point Adapter to the Motor

Guides the installation of the ESP sensor using a WYE point adapter.

Installing the Resistance Temperature Detector “RTD”

Explains how to install the RTD for motor temperature monitoring.

Installing the ESP Sensor with Single Wire to the Motor

Provides instructions for installing the ESP sensor with a single wire connection.

Discharge Port Connection (ESP-3500 only)

Discharge Port Connection (Spy Pro only)

Testing the ESP Sensor While Installing Tubing

Installing the Surface Interface Equipment

Wiring Detail

ESP Gauge and Surface Control Interface Diagram Components

Installing the Surge Suppressor and Surface Choke

Surface Choke

Surge Panel Protector;Suppressor

Surge Protector;Fuse Block Connections 1 - 8

Appendix 1 Troubleshooting

Sensor to Surface Communication Troubleshooting

Provides steps to troubleshoot communication issues between sensor and surface.

Appendix 2 SCOUT and SPS Error Codes and Corrective Actions

Appendix 5 ESP Sensors - Pass;Fail Criteria

ESP Sensors - Simpson Test Pass;Fail Criteria

ESP Sensors - Megger Test Pass;Fail Criteria

Appendix 6 SPS-1500 Synchronization and Startup