Servend CT-6 - General System Overview

Part Number 020005256 5/15 2-1
Section 2
Installation Instructions
General System Overview
These instructions are provided to assist the qualified
installer. Contact your Manitowoc Beverage Equipment
Service Agent or call Manitowoc Beverage Equipment
for information regarding start-up services. CT Series
dispensers follow the same system layout but do not
have an ice bin.
Typical Internal Carbonation Beverage Dispensing System
The carbonator in the post-mix system normally has two
inlet and one outlet connection. One inlet connects to
the CO
2 inlet. The other inlet connects the municipal
water supply. The outlet carries the carbonated water to
the cold plate inlets at the unit. The outlet of the syrup
supply connects to the appropriate coldplate syrup inlet
fitting. The syrup flows through the coldplate to be
chilled on its way to the valves. The water flows through
the coldplate chilling the plain and carbonated water on
its way to the valves. When both fluids leave the
beverage valve they are mixed in the nozzle of the valve.
Out comes a properly cooled, proper ratio soft drink.
When starting a new beverage system of either type, be
sure the electrically operated valves are turned off.
Assure all connections are made, turn the water supply
on to the dispenser. Open CO
2 tank valve and set all
pressures. Place ice on the coldplate and allow the
coldplate to cool. After the beverage has achieved a
40°F temperature, the ratio of the product (brix) on a
post-mix system may then be set. (See Adjust Syrup to
Water Ratio (Brix) Page 2 - 21)
Important
Failure to follow these installation guidelines may
affect warranty coverage.
1800
75
SYRUP
CO
2
CO
2
Cylinder
CO
2
SYRUP
60
Tap Water
Tap Water
Typical Drop-In
Internal Carbonation
Beverage Dispensing System
Bag-In-Box
Syrup
Carton
BIB Syrup Pump
NOTE:
This is a simplified schematic to
show the basic operation of the
beverage system.
Countertop
CT-8
1522
2323
CT-6
Carbonator Tank
Carbonate, Non-carbonate
Beverage Manifold
Carbonate, Non-carbonate
Beverage Manifold
Carbonator Tank