Server Technology switched pro2 - Page 135

Switched PRO2 – User Guide
Using the Command Line Interface (CLI) • 135
Command
Description
on
Turns on the specified outlet or outlet group.
ostat
Displays the latest status and metrics for all outlets in the system.
password
Changes the password for the current local user.
ping
Tests the ability of the PRO2 to contact an IP address for another Ethernet-enabled device.
pstat
Displays the latest status and metrics for all phases in the system.
reboot
Turns off the specified outlet or outlet group, and then turns it back on after a delay.
Remove Commands
The Remove command group removes outlet groups, LDAP groups, UPS devices, and
local users from the system.
remove group
Removes an outlet group from the system.
remove ldapgroup
Removes an LDAP group from the system.
remove ups
Removes a UPS from the system.
remove user
Removes a local user from the system.
restart
Restarts the system.
senstat
Displays the latest status and metrics for all sensors in the system.
Set Commands
The Set command group sets the configuration values for numerous system areas.
set access
Sets user configuration access.
set banner
Sets the system banner that displays before a user authenticates a user session.
set bluetooth
Sets Bluetooth
®
configuration values.
set branch
Sets branch configuration values.
set cord
Sets cord configuration values.
set dhcp
Sets DHCP configuration values.
set dns
Sets Domain Name System (DNS) server configuration values.
set email
Sets email configuration values.
set energywise
Sets Cisco EnergyWise configuration values.
set feature
Enables new system features.
set ftp
Sets FTP configuration values.
set http
Sets HTTP configuration values.