Server Technology switched pro2 - Page 136

Switched PRO2 – User Guide
Using the Command Line Interface (CLI) • 136
Command
Description
set https
Sets HTTPS configuration values.
set ipv4, set ipv6
Sets IPv4 and IPv6 configuration values.
set ldap
Sets LDAP configuration values.
set ldapgroup
Sets configuration values for LDAP group access rights.
set line
Sets line configuration values.
set loadshed
Sets Smart Load Shedding configuration values.
Note: Only available if the Smart Load Shedding feature is activated.
set location
Sets the system location string.
set net
Sets network mode configuration values.
set ocp
Sets over-current protector (OCP) configuration values.
set outlet
Sets outlet configuration values.
set phase
Sets phase configuration values.
set port
Sets serial port configuration values.
set radius
Sets Radius server configuration values.
set sensor
Sets sensor configuration values.
set snmp
Sets SNMP configuration values.
set sntp
Sets SNTP configuration values.
set spm
Sets Sentry Power Manager (SPM) access configuration values.
set ssh
Sets SSH configuration values.
set syslog
Sets Syslog configuration values.
set tacacs
Sets TACACS+ server configuration values.
set tacpriv
Sets TACACS+ configuration values for privilege level access rights.
set telnet
Sets Telnet configuration values.
set trend
Sets power trending configurations.
set unit
Sets PRO2 configuration values.
set ups
Sets UPS device configuration values.