Server Technology switched pro2 - Page 137

Switched PRO2 – User Guide
Using the Command Line Interface (CLI) • 137
Command
Description
set user
Sets configuration values for local user access rights.
set wlan
Sets the wireless network configuration (for the WLAN solution on specific Wi-Fi capable
PRO2 units).
Show Commands
The Show command group displays the current configuration values in the system.
show access
Shows user access configuration values.
show bluetooth
Shows Bluetooth configuration values.
show branches
Shows branch configuration values.
show cords
Shows cord configuration values.
show email
Shows email configuration values.
show energywise
Shows Cisco EnergyWise configuration values.
show features
Shows the enabled system features.
show ftp
Shows FTP configuration values.
show ldap
Shows LDAP configuration values.
show lines
Shows line configuration values.
show loadshed
Shows Smart Load Shedding configuration values.
Note: Only available if the Smart Load Shedding feature is activated.
show log
Shows the system event log.
show network
Shows network configuration values.
show ocps
Shows over-current protector (OCP) configuration values.
show outlets
Shows outlet configuration values.
show phases
Shows phase configuration values.
show ports
Shows port configuration values.
show radius
Shows Radius server configuration values.
show sensors
Shows sensor configuration values.
show shutdown
Shows outlet shutdown configuration values.
show snmp
Shows SNMP configuration values.
show sntp
Shows SNTP configuration values.