Warnings for the installer and general safety
1) It is important for the safety of the people installing the automatism according to the regulations. A wrong installation or
use of the product might lead to serious damages to people.
2) Read carafully the operating instructions before installing the product.
3) Store the operating instructions for future reference.
4) This automatism has been designed and built exclusively for the use specified in this documentation. Any different use not
stated herain could affect the integrity of the product and/or represent danger situation.
5) SESAMO declines any responsabilty from misuse or different use from which it was intended.
6) Do not install the product in explosive enviroment: the presence of flamabel gases or fumes is a serious safety hazard.
7) SESAMO is not responsible for the failure to comply with the Good Technical construction procedure of the door to be auto-
mated, as well as deformations that may occur to the door when using the same.
8) Before making any service to the product, take off power supply.
9) Instal a bi-polar switch to cut off power supply.
10) Verify functionality of ground wiring.
11) Safety devices (norm EN 12978) protect possible dangerous areas from mechanical risks during movement, as. anticras-
hing, conveying, shearing.
12) For mainteinance use only genuine SESAMO spare parts.
13) Do not modify components that belongs to the whole automatism.
14) The installer must supply end user all the informations in case of manual operating in emergency.
15) End user shall refrain from any attemp to repair or direct intervenction and ask only to qualified personnel.
16) Installation must be done only from a qualified personnel and in full compliance with regulations.
17) Everything not including in this operating instruction manual is not allowed.
18) This operating instructions manual is only intended for qualified personnel.
Recycling and disposal
RECYCLING OF THE AUTOMATISM AND PACKAGING
This product is built with different materials. The major parts (aluminium, plastic, iron,wires) are solid urban waste. They can be
recycled through collection and disposal in authorized centers.
Other components (control boards, etc.) may contain pollutants. They need to be removed and hand over to companies autho-
rized to recover and dispose them.
The packaging (paperboard, plastics etc.) are solid urban waste and they can be disposed of without any problem, simply per-
forming waste collection for recycling.
Before proceding it is always reccomendr to verify local specific norm for disposal.
PLEASE RECYCLE!
7
PROSWING (M)
Operating instruction
To Next Page
Loading...
