SESAMO suggests, for any kind of maintenance, calibration, adjustments and / or modifications, the
intervention of our technicians or local technical authorized.
SESAMO assumes no responsibility for any unauthorized work on their own equipment.
For any repairs and / or replacement, only original parts must be used.
DESCRIPTION AND OPERATION
Power the automatism with the mains voltage of 230V pressing the switch "0-1" on the head of the automation to
position 1. After a while the automatism carries out a low-speed manoeuvre in the closing direction.
When it comes to the closed position after a while is ready to be used in ways that depend on the type of peripherals
and accessories installed and by the logic selected by three way selector present on the head.
The opening of the wings can be controlled by detection sensors, by the advanced or basic selector and by the push
buttons for the manual control; the opening manoeuvre can be followed by a pause or by the automatic reclosing of
the doors depending on the logic chosen (see the description of the logics selector).
The pause of the wings in the open position facilitates the passage of people according to the needs of the customer,
the pause time can be adjusted during installation.
The closing of the wings occurs automatically at the end of the pause time, at a slower speed than the opening.
INSTALLATION WITH ADVANCED SELECTOR
To Next Page
Loading...
