ECShell engineering software
Manual – ECC-DFC field bus controller
In this example, the left-hand pin 2 has been set as a “Wake up” input for the
upstream zone of the module, and the right-hand pin 2 has been set as a “Lane
Full” interface for the downstream zone.
Note that the green arrows specify the zone (UP or DOWN) that has been as-
signed to the function of the left or right pin 2.
Also note: If “Lane Full Interface” has been activated at a pin 2, the “Block” and
“Clear” timer selection is displayed. In the example, 3 seconds has been set for
the “Block” time and 4 seconds for the “Clear” time.
To Next Page
Loading...
