10
Operation
General information
Product Manual – MOVIDRIVE
®
modular
412
10 Operation
10.1 General information
DANGER
Dangerous voltages present at cables and motor terminals.
Severe or fatal injuries from electric shock.
• Dangerous voltages are present at the output terminals and the cables and motor
terminals connected to them when the device is switched on. This also applies
even when the device is inhibited and the motor is at standstill.
• Check whether the device is disconnected from the power supply before you
start working on the power connections.
• After disconnection from the power supply, wait at least 10minutes and ensure
that there is no voltage present before you start working on the power connec-
tions.
• The fact that the operation LEDs are no longer illuminated does not indicate that
the application inverter no longer carries any voltage.
• Observe the general safety notes in chapter Safety notes.
DANGER
Risk of crushing if the motor starts up unintentionally.
Severe or fatal injuries.
• Ensure that the motor cannot start inadvertently, forexample, by removing the
electronics terminal block X20.
• Additional safety precautions must be taken, depending on the application, to
avoid injury to personnel and damage to machinery.
NOTICE
Switching the motor output at the application inverter with enabled output stage.
Damage to the application inverter.
• The motor output of the application inverter may be switched or disconnected
only when the output stage is inhibited.
25952676/EN – 01/2020
To Next Page
Loading...
Need help?
General
