SEW-Eurodrive MOVIPRO PHC21A-A075M1-E45C-C5 - Page 160

9
Service
Status display
Operating Instructions – MOVIPRO
®
PHC2.A-A..M1-E45C-C5
160
9.2.2 Replacing the device
1. Disconnect the device and remove it from the system.
2. Loosen the connection of the ID module and remove it from the X4401.
3. Plug the ID module into connection X4401 of a new device and tighten the screw.
4. Install the new device in the system and connect it to the supply system.
5. Switch on the new device.
For more information, refer to the "Parameterizable Plant Software MOVIVISION
®
 –
MOVIPRO
®
Software Interface" manual.
9.3 Status display
The statusdisplay shows status and error messages and thus enables you to record
the current state of the device.
For more information refer to chapter Status and error messages and the documenta-
tion on the user program (for the respective system solution). In case of questions,
contact SEW‑EURODRIVE.
9.4 Fault information
INFORMATION
For more information on the fault memory and on acknowledging fault messages,
refer to chapter "Fault information"(→2157).
26596598/EN – 10/2020