SEW-Eurodrive MOVIPRO PHC21A-A075M1-E45C-C5 - Mechanical Installation; Requirements

5
Mechanical installation
Requirements
Operating Instructions – MOVIPRO
®
PHC2.A-A..M1-E45C-C5
44
5 Mechanical installation
5.1 Requirements
WARNING
Risk of crushing if the load falls.
Severe or fatal injuries.
• Do not stand under the load.
• Secure the area where loads can fall down.
• Trained specialists perform the installation.
• The information provided in the technical data and the permitted conditions for the
operating location of the device are observed.
• The minimum clearance and the required gaps for using a mounting plate are
complied with. For more information, refer to chapter "Minimum clear-
ance"(→245).
• The device is only mounted using the intended mounting options.
• The selection and dimensioning of the mounting and locking elements are in line
with the applicable standards, the technical data of the devices and the local re-
quirements.
• The bore dimensions are calculated in line with the respective type of fixture. For
more information, refer to chapter "Assembly"(→249).
• The mounting and locking elements fit into the existing bores, threads and counter-
sinks.
• All display and actuator elements are visible and accessible after installation.
• The device is positioned in a way that it will not collide with other components or
design elements along the travel path.
• Fasten the device so that it is not exposed to shocks or vibrations during operation
that exceed loads according to DINEN60721-3-3/-5 3M7/5M2.
26596598/EN – 10/2020