SEW-Eurodrive MOVIPRO PHC21A-A075M1-E45C-C5 - Assembly

5
Mechanical installation
Assembly
Operating Instructions – MOVIPRO
®
PHC2.A-A..M1-E45C-C5
49
5.5 Assembly
CAUTION
Risk of injury due to sharp edges.
Minor injuries.
• Wear suitable protective gloves.
INFORMATION
To avoid excessive force on threads or screws, do not exceed the maximum tighten-
ing torque of 3.2 Nm.
Use one of the following mechanical mounting options:
• Mounting with mounting brackets
• Mounting via through bores
5.5.1 Mounting with mounting brackets
Required material
• "Large bracket mounting set" accessories (part number 12708305):
– 4mounting brackets
– 8 studs M5×8
• Holding fixture, e.g. square pipe with an edge length ≤32mm
• Suitable mounting and safety elements
– For mounting at device: Studs M5×8 (included in mounting kit), M8× 30
– For mounting at the holding fixture: M6 screws of suitable length with washers
26596598/EN – 10/2020