5
Mechanical installation
Assembly
Operating Instructions – MOVIPRO
®
PHC2.A-A..M1-E45C-C5
50
Fastening the mounting plates
The following figure provides an overview on mounting with mounting brackets:
[1]
[2]
[6][5]
[4]
[3]
[10] [8] [7][9]
72057594453791499
[1] Device
[2] Large mounting bracket
[3] Through bore Ø 6.6mm
[4] M5 × 8 stud
[5] Tapped hole for stud M5×8
[6] Bore for screw M8 ×30
[7] T-slot
[8] Tapped hole for M6 screw
[9] Tapped hole for M8 screw
[10] Holding fixture, e.g. square pipe with an edge length ≤32mm
Procedure
1. Insert the mounting brackets [2] into the T-slots [7] of the device [1] so that the up-
per edge of the bracket is flush with the upper end of the slot.
2. In order to prevent the mounting bracket [2] from slipping out of position in the T-
slot [7], fix the mounting bracket with M8 × 30 screws [6] in the through holes of
the device.
3. Screw the supplied M5 × 8 studs [4] into the T-slot [7].
4. Repeat the steps for the other mounting brackets [2].
26596598/EN – 10/2020
To Next Page
Loading...
