SEW-Eurodrive MOVIPRO PHC21A-A075M1-E45C-C5 - Page 171

10
Technical data
Communication and control unit
Operating Instructions – MOVIPRO
®
PHC2.A-A..M1-E45C-C5
171
10.10.2 DC24V output
DC24V output X2312
Nominal output voltage DC24V
Nominal output current DC 500mA
Output current limit Maximum 1.4A
10.10.3 Ethernet fieldbus interface
Ethernet fieldbus interface X4233
Transmission rate 10/100Mbit/s
Properties Half/full duplex, auto negation, auto crossover
Maximum cable length 100m according to IEEE 802.3
10.10.4 CAN interfaces
CAN interfaces X4101/X4111
General According to CAN specification 2.9, parts A and B
Transmission technology according to ISO11898
A maximum of 64 stations
Baud rate 125kBaud–1MBaud
Maximum cable length Depends on the baud rate according to CAN specification
Bus termination
X4111
X4101
120Ohm terminated in the device
No integrated terminating resistor
10.10.5 RS485 interface
RS485 interface X4011
General I/O standard
Baud rate 2.4–115.2 kBaud
Bus termination The interface is equipped with a dynamic terminating resistor inside the
device.
26596598/EN – 10/2020