Sharp Aquos LC-42D62U

Basic adjustment settings
This 1V provides various advanced functions for
optimizing the picture quality.
Provides high quality images with minimal dot crawl
and cross color noise.
Press MENU to display the MENU screen,
and then press
~/~ to select "Picture".
Standard
Normal adjustment
Press .. IT to select "Advanced", and then
press
ENTER.
Fast
Slow
For moving images
For still images
Normal viewing mode
Off
• 3D-Y/C is available for input signal from Composite Video
and ANALOG
IN.
Automatically detects a film-based source (originally
encoded at 24 frames/second), analyzes
it then
recreates each still film frame for high-definition picture
quality.
For viewing a video
in monochrome.
t
White with Reddish tone
White with Bluish tone
Press ./T (or ~/~) to select the desired
parameter.
• See the table for the selectable parameters.
Press .. IT to select a specific adjustment
item, and then press
ENTER.
• You can select "Color Temp.", "Black", "3D-YI
C", "Monochrome", "Film Mode"
or "Range of
OPC".
Press MENU to exit.
High
Mid-High
Middle
Mid-Low
Low
For a better white balance, use color temperature
correction.
Changes the viewing depth by automatically adjusting
the dark portion of
an image for easier viewing.
Detects, analyzes, converts film
source
On
The brightness level range of the OPC sensor's
automatic adjustments can be set according to your
preferences. The adjustment range of the OPC sensor
can be set to a maximum of
+ 16 and a minimum of
-16.
For high detail in black portions
No adjustment
Off
On
Max.
- 15 through + 16
Min. - 16 through +15
• The range
of OPC settings are active only when the OPC is
set to On.
• The maximum setting cannot be set
to a smaller number
than the minimum setting.
• The minimum setting cannot be set to a bigger number
than the maximum setting.
• Depending on the brightness of the surrounding light, the
OPC sensor might not operate if the adjustment range
is
small.
@-26