@-so
Appendix
Problem
Possible Solution
• No power
• Check if you pressed
TV POWER on the remote control unit.
(See
page 15.) if the
indicator on the TV does not light up, press
POWER on the
TV.
•
Is
the AC cord disconnected? (See page
7.)
• Has the power been turned on?
(See
page 15.)
• Unit cannot be operated.
• External influences such as lightning, static electricity, may cause improper
operation.
In
this case, operate the unit after first turning on the power of the TV or
unplugging the AC cord and replugging it
in
after 1 or 2 minutes.
• Remote control unit does not
..
Is
the FUNCTION set correctly? Set it to the TV setting position.
operate.
• Are batteries inserted with polarity (+,
-)
aligned?
(See
page
8.)
• Are batteries worn out? (Replace with new batteries.)
• Are you using
it
under strong or fluorescent lighting?
•
Is
a fluorescent light illuminated near the remote control sensor?
• Picture
is
cut off/with sidebar
•
Is
the image position correct?
(See
page 31.)
screen. • Are screen mode adjustments such as picture size made correctly?
(See
pages 33
and 34.)
• Strange color, light color, or color
e Adjust the picture tone.
(See
pages 25 to 26.)
misalignment •
Is
the room too bright? The picture may look dark
in
a room that
is
too bright.
• Check the input signal setting.
(See
page 36.)
• Power
is
suddenly turned off.
•
Is
the sleep timer set?
(See
page 32.)
• Check the power control settings.
(See
page 28.)
• The
unifs
internal temperature has increased. Remove any objects blocking vent
or clean.
• No picture
•
Is
connection to other components correct?
(See
pages 13 and 14.)
•
Is
correct input signal source selected after connection?
(See
page 29.)
•
Is
the correct input selected? (See page 29.)
•
Is
picture adjustment correct?
(See
pages 25 to 26.)
•
Is
"On" selected
in
"Audio Only"?
(See
page 35.)
•
Is
a non-compatible signal being input?
(See
page 14.)
• No sound
•
Is
the volume too low?
(See
page 18.)
•
Is
"Variable" selected
in
"Output Select"?
(See
page 35.)
• Have you pressed
MUTE on the remote control unit? (See page 18.)
The error message about reception
of
broadcast
The example of an error
Error code
Possible Solution
message displayed on a screen
• Failed to receive broadcast.
E202
• Check the antenna cable. Check that the antenna
is
correctly
setup.
• No broadcast now.
E203
• Check the broadcast time
in
the program guide.
Cautions regarding use
in
high and low temperature environments
• When the unit
is
used
in
a low temperature space (e.g. room, office), the picture may leave trails or appear slightly delayed.
This
is
not a malfunction, and the unit will recover when the temperature returns to normal.
• Do not leave the unit
in
a hot or cold location. Also, do not leave the unit
in
a location exposed to direct sunlight or near a
heater, as this may cause the cabinet to deform and the Liquid Crystal panel
to
malfunction.
Storage temperature: - 4°F to
+140°F (- 20°C to +60°C)
To Next Page
Loading...
