Using external equipment
To view external source images, select the input source
from
INPUT on the remote control unit or on the
TV.
If
the image does not come
in
clearly from the external
equipment connected
to
INPUT 1 or
2,
you may need
to change the input signal type setting on the "Input
Select" menu.
INPUT
FLASHBACK
o
Press MENU to display the MENU screen,
and then press
......
/~
to select "Option".
Press
./T
to select the signal type you
want to set, and then press
ENTER.
•
If
the selected signal type
is
incorrect, images
are not displayed
or
displayed without any color.
Press MENU to exit.
• The setting
is
stored and can be selected on the
"INPUT SOURCE" menu.
Press
./T
to select "Input Select", and then
press
ENTER.
• Refer to your external equipment operation manual for the
signal type.
•
If
you set INPUT 1 and INPUT 2 to Auto, the
1V
will
automatically select the input signal.
• Check the operation manual of the external equipment for
the signal type.
• Setting INPUT 1 and INPUT 2 signal selection to "Auto"
when other equipment
is
connected will result
in
the
following connection priority.
INPUT 1 and INPUT
2:
CD
COMPONENT VIDEO
(g)VIDEO
- VOL + V
CH
A INPUT POWER
VOL CH
SURROUNO{J
A MUTE
o -
(j
0
FREEZE
MENU
°tdftil
...
-
Press INPUT.
• A list of selectable sources appears.
Press INPUT again to select the input
source.
•
An
image from the selected source automatically
displays.
• Each time
INPUT
is
pressed, the input source
toggles.
• You can also select the input source by pressing
./T.
•
If
the corresponding input
is
not plugged
in,
you
cannot change the input. Be sure to connect the
equipment beforehand.
• See pages 13 and 14 for external equipment connection.
@-29
To Next Page
Loading...
