@)-2
IMPORTANT
INFORMATION
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG
TO
WIDE
SLOT~
FULLY INSERT.
CAUTION:
DO
NOT PLACE THIS PRODUCT
ON
AN
UNSTABLE
CART,
STAND,
TRIPOD,
BRACKET,
OR
TABLE. THE PRODUCT
MAY
FALL
CAUSING SERIOUS PERSONAL INJURY AND SERIOUS
DAMAGE
TO
THE PRODUCT
USE
ONLY
WITH
A
CART,
STAND,
TRIPOD,
BRACKET,
OR
TABLE
RECOMMENDED BY THE MANUFACTURER
OR
SOLD WITH THE PRODUCT FOLLOW THE
MANUFACTURER'S INSTRUCTIONS WHEN INSTALLING
THE
PRODUCT AND
USE
MOUNTING
ACCESSORIES RECOMMENDED BY THE MANUFACTURER. A PRODUCT AND CART
COMBINATION SHOULD
BE
MOVED
WITH CARE. QUICK STOPS,
EXCESSIVE
FORCE,
AND
UNEVEN
SURFACES
MAY
CAUSE THE PRODUCT AND CART COMBINATION
TO
OVERTURN.
WARNING:
FCC Regulations state
that
any unauthorized changes or
modifications
to
this
equipment
not
expressly
approved
by
the
manufacturer
could
void
the
user's authority
to
operate this equipment.
CAUTION:
This
product
satisfies FCC regulations
when
shielded cables and
connectors
are used
to
connect
the
unit
to
other
equipment.
To
prevent electromagnetic interference
with
electric appliances such as radios and televisions, use
shielded cables and
connectors
for
connections.
DECLARATION OF CONFORMITY:
SHARP LIQUID CRYSTAL TELEVISION, MODEL LC-42D62U
This device complies with Part 15
of
the FCC Rules. Operation is subject to the following
two
conditions:
(1)
This device may not cause harmful interference, and
(2)
this device must accept any interference
received, including interference that may cause undesired operation.
RESPONSIBLE PARTY:
SHARP ELECTRONICS CORPORATION
Sharp Plaza, Mahwah,
New
Jersey
07430-2135
TEL: 1-800-BE-SHARP
For Business Customers:
URL
http://www.sharpusa.com
INFORMATION:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to
Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in
a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in
accordance with the instructions, may cause harmful interference to radio communications. However, there
is
no guarantee
that interference will not occur
in
a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is
encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
-Increase
the separation between the equipment and receiver.
- Connect the equipment into
an
outlet on a circuit different from that
to
which the receiver is connected.
- Consult the dealer or
an
experienced radiofTV technician for help.
"Note to
CATV
system installer:
This
reminder
is
provided to call the
CATV
system installer's attention to Article 820-40 of the
National Electrical
Code
that provides guidelines for proper grounding
and,
in
particular, specifies that the cable ground
shall
be
connected to
the
grounding system
of
the building,
as
close to the point of cable entry
as
practical."
This
product utilizes tin-lead
solder,
and
fluorescent lamp containing a
small
amount of
mercury.
Disposal of these materials
may
be
regulated
due
to environmental considerations.
For
disposal
or
recycling information, please contact your local authorities or
the
Electronic Industries Alliance: www.eia.org
Trademarks
• Manufactured
under
license
from
Dolby Laboratories. "Dolbyll
and
the
double-D
symbol
are
trademarks
of
Dolby
Laboratories.
• "HDMI,
the
HDMIIogo
and High-Definition
Multimedia
Interface are
trademarks
or
registered
trademarks
of
HDMI
Licensing LLC."
To Next Page
Loading...
