Sharp Aquos R3

111
Handset Settings
1
In the home screen, display “app list screen”▶
[Settings]▶[Network & internet]▶[Wi-Fi]
2
Set [Use Wi-Fi] to ON
3
Select an access point
z
If you select an access point protected by security, enter the
password (security key) and select [CONNECT].
z
To register access points manually: [Add network]
▶
enter the
network name
▶
set security
▶
[SAVE]
z
When you touch [Saved networks], the access point that you
have accessed is displayed.
z
When you connect to Wi-Fi network, [Connected] is displayed.
When a different message is displayed, make sure the
password (security key).
When the connection is not established even if you enter a
correct password (security key), the correct IP address may not
have been acquired. Check the signal status and reconnect.
z
As for the manual registration of an access point, this function
supports WEP, WPA/WPA2 PSK and 802.1xEAP, Enhanced
Open, WPA3 as the security setting.
z
If you connect to an access point which is not connected to the
Internet, [
] is displayed and the communication may be
made by mobile networks, not Wi-Fi connection.

Wi-Fi settings
1
In the home screen, display “app list screen”▶
[Settings]▶[Network & internet]▶[Wi-Fi]▶
[Wi-Fi preferences]
2
Select an item

Turn on Wi-Fi automatically: Set whether to set [Wi-Fi] to ON
when a saved network is detected.

Open network notification: Set whether to display a
notification icon when an open network is detected.
y
Set it after setting [Wi-Fi] to On.

Install certificates: Install certificates.

Network rating provider: Make settings for the network rating
provider.

Wi-Fi Direct: Make settings for Wi-Fi Direct.

MAC address: Confirm the MAC address.

IP address: Confirm the IP address.

Deleting access point settings
1
In the home screen, display “app list screen”▶
[Settings]▶[Network & internet]▶[Wi-Fi]
2
Select an access point already set▶[FORGET]