Sharp Aquos R3

112
Handset Settings
Mobile network
1
In the home screen, display “app list screen”▶
[Settings]▶[Network & internet]▶[Mobile
network]
2
Select a nanoSIM Card
z
If two nanoSIM Cards are inserted, touch the tab on the
screen top and select the nanoSIM Card you wish to set.
3
Select an item

Mobile data: Set whether to access data via mobile
networks.

Roaming: Set whether to connect to a data service at the
time of roaming.

App data usage: For details on app data usage
☞
P. 113
“Data usage”

Enhanced 4G LTE Mode: Set whether to use VoLTE.

Preferred network type: Set a network to use.

Automatically select network: Set whether to automatically
detect and switch to an available network.

Network: When [Automatically select network] is set to OFF,
you select a network manually.

Access Point Names: Set and check an access point.

Setting an access point
Set an access point* to connect to the Internet.
z
Access points supported by some network operators have been
pre-registered in this handset. When the power is turned ON with
a nanoSIM Card inserted, access points are automatically set.
z
If a supported access point is not registered in this handset, you
can additionally set the access points. After that, upon power
ON, the handset will connect to the access point.
* Depending on the network operator, it is called “APN” or “Access
Point Name”.
1
In the home screen, display “app list screen”▶
[Settings]▶[Network & internet]▶[Mobile
network]
2
Select a nanoSIM Card
z
If two nanoSIM Cards are inserted, touch the tab on the
screen top and select the nanoSIM Card you wish to set.
3
[Advanced]▶[Access Point Names]
z
You can check an access point in use.
4
[ ]
5
[Name]▶enter the name of the network profile
to create▶[OK]
6
[APN]▶enter the access point name▶[OK]
7
Enter other items required by network operators
▶[
]▶[Save]