Sharp AR-M256 Service Manual

AR-M256/M257/M258/M316/M317/M318/5625/5631 SIMULATION 8 - 51
Operation/procedure
Press the [START] key.
The confidential ID table (confidential BOX numbers, confidential BOX
names, and confidential password) is printed.
The confidential data of My company mode is printed separately.
Note: Executable only when the FAX is installed.
Operation/procedure
Press the [START] key.
Used to input all image data (including confidential reception data,
remote send image, not-sent image) stored in image memory of the
FAX section.
The output image is remained even after outputting.
Note: Executable only when the FAX is installed.
Operation/procedure
Select “1: YES” with the 10-key and press the [START] key. (When “2:
NO” is selected, the simulation is canceled.)
Used to clear all image data (including confidential reception data)
stored in image memory of the FAX section.
The management table is also cleared (initialized) at the same time.
* lIf there is any print data, the power must be turned off after clearing.
Note: Executable only when the FAX is installed.
Operation/procedure
Select the signal number with the 10-key, and press the [START] key.
By setting the signal number, the specified signal is delivered to the
line at the speed of 300bps. (The signal is continuously sent until the
interruption command is provided by pressing the [CUSTOM SET-
TINGS] key.)
The signal send level can be selected from 0dB or the soft SW set value.
The signal send level is returned to the soft SW set value before execu-
tion of the mode after completion of the mode.
By entering the number and pressing the [START] key during execu-
tion, the signal kind can be changed.
Note: Executable only when the FAX is installed.
66-6
Purpose Data output, check
Function (Purpose) Printing the confidential password
Section FAX
Item Data Confidential/Pass code
66-7
Purpose Data output, check
Function (Purpose) Print the screen memory contents
Section FA X
Item Data Image data
1
1
66-10
Purpose Adjustment/Setting/Check
Function (Purpose) Image data memory clear
Section FA X
Item Data Image data
66-11
Purpose Operation test/check
Function
(Purpose)
Used to send 300bps signals.
(Signal send level: Max.)
Section FAX
Item Operation
Item
1 NO SIGNAL
2 11111
3 11110
4 00000
5 010101
6 00001
1
1

Sharp AR-M256 Specifications

General

Brand	Sharp
Model	AR-M256
Category	All in One Printer
Language	English