21
■
Memorizing a station
You can store 40 AM and FM stations in memory and recall them at the push of a
button. (Preset tuning)
1 Perform the steps 1 - 3 in “Listening to the Radio” on page 20.
2 Press the MEMORY/SET button to enter the preset tuning saving
mode.
3 Within 30 seconds, press the PRESET (
XX
XX
X or
WW
WW
W ) button to select
the preset channel number.
Store the stations in memory, in order, starting with preset channel 1.
4 Within 30 seconds, press the MEMORY/SET button to store that
station in memory.
If the “MEMORY” and preset number indicators go out before the station is
memorized, repeat the operation from step 2.
5 Repeat steps 1 - 4 to set other stations, or to change a preset
station.
When a new station is stored in memory, the station previously memorized will
be erased.
■
To scan the preset stations
The stations saved in memory can be scanned automatically. (Preset memory scan)
1 Press the PRESET (X or W ) button for more than 0.5 seconds.
The preset number will flash and the programmed stations will be tuned in
sequentially, for 5 seconds each.
2 Press the PRESET (X or W ) button again when the desired sta-
tion is located.
■
To recall a memorized station
Press the PRESET (
XX
XX
X or
WW
WW
W ) button for less than 0.5 seconds to se-
lect the desired station.
Note:
The backup function protects the memorized stations for a few hours should there be
a power failure or the AC power cord disconnection.
Preset channel Frequency and frequency band
Radio
– Listening to the memorized station –
Listening to the memorized station
■
To erase entire preset memory
1. Press the ON/STAND-BY button to enter the stand-by mode.
2. Press the ON/STAND-BY button while holding down the TUNER (BAND) button
and X-BASS/DEMO button until “TUNER CL” appears.
*BA3100_P20_21 00.12.8, 11:40 AM21
To Next Page
Loading...
