27
6 Press the TUNING/TIME (
W W
W W
W or
XX
XX
X) button to specify the minute,
then press the MEMORY/SET button.
7 The unit will enter the timer stand-by mode automatically.
To cancel the timer playback/timer recording:
Press the ON/STAND-BY button to turn the power on.
8 When the preset time is reached, playback or recording will start.
The volume will increase gradually until it reaches the volume you were listen-
ing at before your system enters the timer stand-by mode.
9 In timer playback:
If you select CD or TAPE, the unit will enter the stand-by mode after the play-
back.
If you select TUNER, it will enter the stand-by mode one hour after the timer
playback starts.
In timer recording:
When the recording tape reaches its end, the timer recording will end, and the
unit will enter the stand-by mode.
To reset or change the timer setting:
Perform “Timer playback or Timer recording” from the beginning.
Notes:
● Once the time is set, the setting will be retained until a new time is entered.
● When performing timer playback or recording using another unit connected to the
VIDEO/AUX jacks, select “VIDEO/AUX” in step 2. At this time, only this unit will be
turned on or enter the power stand-by mode automatically. It will enter the power
stand-by mode when the end of the recording tape is reached in timer recording or
1 hour after the playback starts in timer playback. However, another unit will not be
turned on or off.
Timer and Sleep Operation (continued)
■
Sleep operation
1 Play back the desired sound source.
2 Press the TIMER/SLEEP button repeatedly until “SLEEP” is dis-
played.
To change the sleep time:
While the sleep time is displayed, press the TUNING/TIME (X or W) button.
(Maximum: 3 hours - Minimum: 1 minute)
● 3 hours - 5 minutes → 5-minute intervals
● 5 minutes - 1 minute → 1-minute intervals
3 Press the MEMORY/SET button.
4 Your system will enter the power stand-by mode automatically
after the preset time has elapsed.
The volume will be turned down 1 minute before the sleep operation finishes.
To cancel the sleep operation:
Press the ON/STAND-BY button while the sleep timer is set.
To confirm the remaining sleep time:
Press the TIMER/SLEEP button while the sleep timer is set.
The remaining sleep time is displayed for about 5 seconds.
Note:
Once the sleep time is set, it will remain unchanged until the setting is changed.
Advanced Features
– Timer and Sleep Operation –
■ Listening to the Radio (See page 20.)
*BA3100_P26_28 00.12.8, 11:43 AM27
To Next Page
Loading...
Need help?
General
