24
Tape Recording
– Recording from a CD (CDs) –
You can record the desired CD using the s 1 - s 6 buttons.
1 Press the ON/STAND-BY button to turn the power on.
2 Load a cassette into the TAPE 2 cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be performed.
3 Press the CD button and load the desired disc.
4 Press the REC PAUSE
(
I6I6
I6I6
I6) button.
Recording will be paused.
5 Press one of the
s s
s s
s 1 -
s s
s s
s 6
buttons to start recording.
● CD playback will start approximately 5 seconds after the tape starts.
● When the playback of the disc is finished or the end of the tape is reached,
the CD and the cassette will stop automatically.
Recording from several CDs continuously:
1. Follow the above steps 1-4.
2. Press the 0/R (TAPE 2 0) button.
Recording will start from the disc of the lowest number.
To perform programmed recording:
1. Program discs and tracks (page 19).
2. Press the REC PAUSE (I6) button.
3. Press the 0/R (TAPE 2 0) button.
To stop recording:
Press the ■ (CD ■) button.
The CD and tape will stop.
Note:
When the end of the tape is reached while recording, the CD player will display the
track number which was being played at that time, and stop automatically.
If you want to restart recording from the interrupted track, turn over the tape, press the
REC PAUSE (I6) button and then the 0/R (TAPE 2 0) button.
(If tracks have been stored in memory using the programmed recording, recording will
restart from the first track stored in memory.)
Recording from a CD (CDs)
■ Programmed Play (See page 19.)
*BA3100_P23_25 00.12.12, 4:43 PM24
To Next Page
Loading...
Need help?
General
