24
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
Listening to a Cassette Tape
1 Press the ON/STAND-BY button to turn the power on.
2 Press the TAPE button.
3
Open the cassette door by pushing the area marked “PUSH EJECT
77
77
7”.
PUSH EJECT
7
4 Load the cassette into the compartment with side A facing you.
5
Press the REV. MODE button on the remote control to choose one
side or both sides.
6
Press the
0606
0606
06 button to listen to side A, or the
11
11
1 button for side B.
● To play both sides ( ), start from side A. When playback starts from side B,
side A will not be played.
● To play side B using the remote control, press the ■ button to switch the
playback side. Then, press the 06/D button.
To stop playback:
Press the ■ button.
Fast forward/rewind on side A:
To advance the tape, press the 2 button.
To rewind it, press the 3 button.
Fast forward/rewind on side B:
To advance the tape, press the 3 button.
To rewind it, press the 2 button.
Caution:
● To remove the cassette, press the ■ button, and then open the compartment.
● If a power failure occurs during tape operation, the tape head will remain engaged
with the tape and the cassette door will not open. Wait until power is restored.
● Even if the 06 button is pressed during tape playback, the unit will not enter the
pause mode.
... To listen to both sides.
...
For endless repeat play of both sides.
... To listen to one side.
Tape Playback
To Next Page
Loading...
Need help?
General
