42
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
Recording to a Cassette Tape from a MiniDisc
1 Press the ON/STAND-BY button to turn the power on.
2 Press the MD button and load a MiniDisc into the MD compart-
ment, label side up. (See page 36.)
3 Load a cassette into the compartment with side A facing you.
4
Press the REV. MODE button on the remote control to choose one
side or both sides.
5 Press the TAPE REC button repeatedly to switch to the side you
record on.
● Recording will be paused.
● To record on both sides, begin on side A. (If recording is started from side B,
the tape will not switch over to side A.)
6 Press the
0606
0606
06 button to record on side A, or the
11
11
1 button for
side B.
● When you press the 06/1
0 button on the remote control, the system will
record on the side specified in step 5.
● When the MiniDisc reaches the end, recording will stop.
To perform programmed recording:
1. Programme discs and tracks. (See page 22.)
2. Press the TAPE REC button.
3. Regardless of the tape setting (step 5), press the 06 button to record on side A, or
the 1 button for side B.
To interrupt recording:
Press the TAPE REC button.
To resume recording, press the same recording button you pressed in step 6. Other
buttons do not allow resuming.
To stop recording:
Press the ■ button.
The MiniDisc and tape will stop.
Auto restart function:
If the recording side is switched from side A to B during recording, the system will
record the interrupted track on side B from its beginning.
The recording will be made without cutting the beginning of the track on side B.
.... To record on both sides.
.... To record on only one side.
Tape Recording
To Next Page
Loading...
