41
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
Recording to a Cassette Tape from a CD
You can record the desired CD using the DISC 1 - DISC 6 buttons.
1 Press the ON/STAND-BY button to turn the power on.
2 Press the CD button and load the desired disc.
3 Load a cassette into the compartment with side A facing you.
● When recording important selections, make a preliminary test to ensure that the
desired material is properly recorded.
● The volume and sound controls can be adjusted with no effect on the recorded
signal (Variable Sound Monitor).
● Do not use metal and CrO2 tapes for recording.
4
Press the REV. MODE button on the remote control to choose one
side or both sides.
5 Press the TAPE REC button repeatedly to switch to the side you
record on.
● Recording will be paused.
● To record on both sides, begin on side A. (If recording is started from side B,
the tape will not switch over to side A.)
6 Press one of the DISC 1 - DISC 6 buttons to start recording.
● When the CD reaches the end, recording will stop.
Recording from several CDs continuously:
1. Follow the above steps 1 - 5.
2. Regardless of the tape setting (step 5), press the 06 button to record on side A, or
the 1 button for side B.
● Recording will start from the lowest numbered disc.
To perform programmed recording:
1. Programme discs and tracks. (See page 22.)
2. Press the TAPE REC button.
3. Regardless of the tape setting (step 5), press the 06 button to record on side A, or
the 1 button for side B.
To stop recording:
Press the ■ button.
The CD and tape will stop.
Auto restart function:
If the recording side is switched from side A to B during recording, the system will
record the interrupted track on side B from its beginning.
The recording will be made without cutting the beginning of the track on side B.
.... To record on both sides.
.... To record on only one side.
Tape Recording
To Next Page
Loading...
Need help?
General
