43
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
Recording to a Cassette Tape from the Radio
1 Tune in to the desired station. (See page 25.)
2 Load a cassette into the compartment with side A facing you.
3
Press the REV. MODE button on the remote control to choose one
side or both sides.
4 Press the TAPE REC button repeatedly to switch to the side you
record on.
● Recording will be paused.
● To record on both sides, begin on side A. (If recording is started from side B,
the tape will not switch over to side A.)
5 Press the
0606
0606
06 button to record on side A, or the
11
11
1 button for
side B.
● When you press the 06/1
0 button on the remote control, the system will
record on the side specified in step 4.
To interrupt recording:
Press the TAPE REC button.
To resume recording, press the same recording button you pressed in step 5. Other
buttons do not allow resuming.
To stop recording:
Press the ■ button.
Note:
If you hear a whistling noise whilst recording an AM station, move the AM loop aerial.
■
Erasing recorded tapes
1. Press the TAPE button.
2. Follow steps 2 - 5 in “Recording to a Cassette Tape from the Radio”.
.... To record on both sides.
.... To record on only one side.
Tape Recording
To Next Page
Loading...
