55
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
References
Error Messages
Error messages
BLANK DISC
CAN'T COPY
CAN'T EDIT
CAN'T READ
(
:Number or
symbol)
CAN'T REC
CAN'T WRITE
DISC FULL
E-CD 20
E-MD
( :Number or
symbol)
EDIT OVER
MD NO DISC
CD NO DISC
Remedy
● Replace it with another disc.
● Replace the CD.
●
Change the stop position of the
track and then try editing it.
● Replace it with another disc.
● Erase the disc and try record-
ing again.
● Re-record or replace the
MiniDisc.
● Set this unit to the stand-by
mode and try to write the
TOC again. (Remove any
source of shock or vibration
whilst writing.)
● Replace the disc with another
recordable disc.
● Set this unit to the stand-by
mode and turn the power on
again.
● Set this unit to the stand-by
mode and turn the power on
again.
● Decrease the number of
tracks.
● Load a MiniDisc.
● Reload the MiniDisc.
● Load a CD.
● Reload the CD.
Meaning
● Nothing is recorded.
(Neither music nor disc name
is recorded.)
● You tried to record from a
copy prohibited CD.
● A track cannot be edited.
● The disc is damaged.
● TOC information cannot be
read.
● MiniDisc not specified.
● Recording cannot be per-
formed correctly due to vibra-
tion or shock in the unit.
● The TOC information could
not be created properly due
to a mechanical shock or to
scratches on the disc.
● The disc is out of recording
space.
● The CD tray is not working
properly.
● A MiniDisc is not working
properly.
● You chose 32 or more tracks
for track editing.
● A MiniDisc has not been
loaded.
● The MiniDisc data cannot be
read.
● A CD has not been loaded.
● The CD data cannot be read.
When an error message is displayed, proceed as follows:
Error messages
NAME FULL
NO SIGNAL
NOT AUDIO
OVER
PLAY MD
PROTECTED
TEMP OVER
TOC FORM
( :Number or
symbol)
TOC FULL
? DISC
Meaning
● The number of characters for
the disc name or track name
exceeds 40.
● Poor connection of the digital
cable.
● No output signal comes out
from the connected unit to
playback.
● The data recorded on this
disc is not audio data.
● There is no space to make
CD editing on the disc.
● You tried to record on a play-
back-only disc.
● The disc is write protected.
● The temperature is too high.
● TOC information recorded on
the MD does not match the
MiniDisc specifications or it
cannot be read.
● There is no space left for re-
cording track numbers.
● There is no space left for re-
cording character informa-
tion.
● The data contains an error.
● MiniDisc not specified.
Remedy
● Shorten the disc or track
name.
● Connect the digital cable
securely.
● Playback with the connected
unit.
● Select another track.
● Replace the disc.
● Replace it with a disc that has
enough time to record.
● Replace it with another re-
cordable disc.
● Move the write protection tab
back to its original position.
● Set this unit to the stand-by
mode and wait for a whilst.
● Replace it with another disc.
● Erase the disc and try record-
ing again.
● Replace it with another re-
cordable disc.
● Erase the needless charac-
ters.
● Replace it with another disc.
To Next Page
Loading...
Need help?
General
