48
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
MD Editing
Editing a Recorded MiniDisc (continued)
■
To combine tracks
1 Press the MD button and load a MiniDisc. (See page 36.)
2 Whilst in the stop mode, select the second of the two adjacent
tracks you want to combine using the jog dial. Or start playing
the second of the two tracks you want to combine, and then press
the
0606
0606
06 button.
3 Press the NAME/TOC EDIT button, and within 10 seconds, se-
lect “COMBINE” using the jog dial.
4 Within 10 seconds, press the ENTER button.
● To cancel the operation, press the ■ button.
5 Press the ENTER button again.
● The two tracks are combined, and the unit is stopped at the beginning of the
combined track.
● The numbers assigned to the tracks following the combined track are auto-
matically decreased by one.
Notes:
● First, put the two tracks next to each other in the order you want using the MOVE
function. Then combine them using the COMBINE function.
● The first track name will be used. However, when the first track does not have a
name, the second track name will be used.
● This function cannot be used in the random play mode and programmed play mode.
In the following cases, tracks may not be combined.
● Digital recorded track and analogue recorded track.
● Long play recorded track and stereo recorded track.
● Tracks whose recording time is less than 12 seconds.
To Next Page
Loading...
Need help?
General
