234
CHAPTER 11
3. Press
®
.
• To return to the graph movement mode, follow one
of these two methods.
On the screen shown to the right,
1
Touch any part on the left portion of the screen
where the graph is displayed with the pen.
2
Press
Å
<.
Either of the above operations makes it possible to enter
the graph movement screen shown to the right, allowing
you to move the graph.
* In the above example, since the graph for [3: (X–2)
2
] has been selected, that equation becomes a
base equation immediately after the graph movement screen is displayed. (Therefore, if the
equation [2: (X–2)
2
+ 1] has been selected, that equation becomes a base equation.)
* Note that the above operation clears equations not saved on the previous graph movement
screen.
Supplementary explanation:
1. To quickly move the graph, touch a point with the
pen to where you wish to move the graph, as shown
to the right. (Or keep the cursor movement key
pressed until the desired ∆X and ∆Y are obtained. In
the example to the right, press > > >
≤ ≤.)
2. “
” showing the destination point will appear on the
screen and an arrow mark located at that point is
enlarged.
EL-9650-(11)En (229-238) 8/1/00, 9:29 AM234
To Next Page
Loading...
