Sharp er-3100 - Page 21

S10 interface.
This enables RAMs to be loaded with
saved data after master resetting 1 even if their
contents are destroyed.
Master resetting 1:
Memory all clear start (masterreset start)
For master resetting 1, plug in the register,
holding down the journal feed key in the SRV mode.
3. If master reset (MRSI or MRS2) is performed at the
ER-31OO equippedwith the R22113ROM as a common ROM
after the ER-31RS2ROM has been installedin it, it
is automatica~lyloaded with SSP data to activate the
ER-31RS2 program. At this time every SSP data
already programmed is cleared.
Accordingly,it is
necessary to program the programmed SSP data again
after master reset has been performed.
If the ER-31OO is equippedwith any version other
than the R221B comon ROM, it
loaded with the SSP data; and
is not cleared. The SSP data
loaded into the ER-31OO is as
SSP No.: ER31OO-OO1
1. 01
2. 01
3. 134
4. 244
5. 00
6. 134
7.
246
8. 00
9. 06
10. 24
11. 131
12. 01
13. 00
14. 24
15. 189
16. 183
17. 84
18.
122
is not automatically
the programmed SSP data
that is automatically
follows:
–17–