7-60
SYSTEM SETTINGS
Contents
Resetting user counts
Select a user in the setting screen and touch the [Reset] key. A count reset screen for that user will appear.
The reset screen will vary depending on whether a single user or multiple users were selected. The items displayed in
each case are described in the table below.
When a single user is selected
When multiple users are selected
Card Setting
(when the HID card reader is available.)
Configure this setting if user authentication will be performed using a Sharp OSA external authentication application and
an HID card.
Card Reader Device Registration
In this setting, the product ID and vender ID of the connected HID card reader are displayed. To store the HID card
reader, touch the [Read] key.
* For settings that enable an HID card to be used, consult your service technician.
Item Description
Next This shows the next user (in the order of the registration numbers).
Previous This shows the previous user (in the order of the registration numbers).
Show Counts The counts and the number of pages remaining of the selected user are shown by function.
Clear Count Reset the count of the selected item to "0".
Clear All Counts Reset all items of the selected user to "0".
Item Description
Show Counts The counts and the number of pages remaining of the selected users are shown by function.
Clear Count Reset the count of the selected item to "0".
Clear All Count Reset all items of the selected users to "0".
To Next Page
Loading...
Need help?
General
