Sharp MX-B402

2-61
COPIER
Contents
GENERAL PROCEDURE FOR USING STAMP
To select stamp settings, follow the steps below.
1
Place the original.
Place the original face up in the document feeder tray, or face down on the document glass.
When using this function with a portrait original on the document glass, place the original so that the top of the image is to the
right.
Place the original in the automatic document feeder.
☞ PLACING ORIGINALS IN THE AUTOMATIC DOCUMENT FEEDER (page 1-37)
After placing the original, specify the original size.
☞ ORIGINAL SIZES (page 2-29)
2
Select the special modes.
(1) Touch the [Special Modes] key.
(2) Touch the [Stamp] key.
☞ Special modes menu (1st screen) (page 2-41)
A
Top of image to
the right