3 Flex, fan, and align the paper edges before loading.
4 Load the paper stack with the printable side facedown, and then make sure that the guides fit snugly against
the paper.
Notes:
• Load letterhead facedown with the header toward the front of the tray for one‑sided printing.
• Load letterhead faceup with the header toward the back of the tray for two‑sided printing.
• Do not slide paper into the tray.
• To avoid paper jams, make sure that the stack height is below the maximum paper fill indicator.
5 Insert the tray.
If necessary, set the paper size and paper type from the control panel to match the paper loaded.
Set up, install, and configure 28
To Next Page
Loading...
