MX-M350/M450 N/U SIMULATION 9 - 24
4) Press [START] key.
The list of the ON time of the sensors and the detectors of the
paper transport section is printed. When a paper jam or misfeed is
generated, the ON time of each sensor and detector is checked to
check if the operation of the sensor and the detector, paper feed,
and transport are normal or not.
Operation/Procedure
1) Select the counter to be cleared with 10-key.
2) Press [START] key.
The confirmation to clear is opened.
3) Select Yes/NO of counter clear with 10-key.
YES: Clear
NO: Not clear
4) Press [START] key.
* = PAPER JAM, SPF JAM, TROUBLE
Operation/Procedure
1) Select the counter to be cleared with 10-key.
2) Press [START] key.
The confirmation to clear is opened.
3) Select Yes/NO of counter clear with 10-key.
YES: Clear
NO: Not clear
4) Press [START] key.
* = TRAY1, TRAY2, TRAY3/LCC1, TRAY4/LCC2, BPT,
ADU
0 TRAY SELECT AUTO
ONLY
Auto only (No selection allowed)
1 PRINT START Print execution
Print of the set data is executed.
2 PRINT PATTERN Print pattern
1. Paper transport time data
24
24-1
Purpose Data clear
Function
(Purpose)
Used to clear the misfeed counter, the misfeed
history, the trouble counter, and the trouble history.
(The counters are cleared after completion of
maintenance.)
Item Counter
1 PAPER JAM Number of paper jams
2 SPF JAM Number of SPF jams
3 TROUBLE Number of troubles
1
SIMULATION 23-80
DATA PRINT MODE. SELECT SETTING, AND PRESS START.
0. TRAY SELECT :AUTO ONLY
1. PRINT START
2. PRINT PATTERN:1
1
SIMULATION 23-80
0
SIMULATION 23-80
DATA PRINT MODE. EXECUTING
...
.
0. TRAY SELECT :1
Select 1 and
press [START] key.
Press [SYSTEM SETTINGS] key
or [START] key.
Press [SYSTEM SETTINGS] key
or [START] key.
Select 2 and press [START] key.
DATA PRINT MODE. INPUT VALUE, AND PRESS START.
(PRINT PATTERN)
INPUT 1.
Press [START] key. Press [SYSTEM SETTINGS] key or [START] key.
24-2
Purpose Data clear
Function
(Purpose)
Used to clear the number of use (the number of
prints) of each paper feed section.
Section Paper feed
Item Counter
1 TRAY1 Tray 1 use quantity
2 TRAY2 Tray 2 use quantity
3 TRAY3/LCC1 Tray 3/LCC left tray use quantity
4 TRAY4/LCC2 Tray 4/LCC right tray use quantity
5 BPT Manual feed tray use quantity
6 ADU Duplex feed quantity
Press [START] key. Press [SYSTEM SETTINGS] key or [START] key.
SIMULATION 24-1
JAM/ TROUBLE COUNTER DATA CLEAR. SELECT1-3, AND
PRESS START.
1. PAPER JAM
2. SPF JAM
3. TROUBLE
1
SIMULATION 24-1
* COUNTER DATA CLEAR.
ARE YOU SURE?
1. YES
2. NO
1
1
SIMULATION 24-2
PAPER FEED COUNTER DATA CLEAR. SELECT1-6, AND PRESS
START.
1. TRAY1 2. TRAY2
3. TRAY3/LCC1 4. TRAY4/LCC2
5. BPT 6. ADU
SIMULATION 24-2
* COUNTER DATA CLEAR.
ARE YOU SURE?
1. YES
2. NO
1
To Next Page
Loading...
