Sharp MX-M350 - Page 164

MX-M350/M450 N/U SIMULATION 9 - 25
Operation/Procedure
1) Select the counter to be cleared with 10-key.
2) Press [START] key.
The confirmation to clear is opened.
3) Select Yes/NO of counter clear with 10-key.
YES: Clear
NO: Not clear
4) Press [START] key.
* = SPF, SCAN, STAPLER, PUNCH, STAMP
Operation/Procedure
1) Select the counter to be cleared with 10-key.
2) Press [START] key.
The confirmation to clear is opened.
3) Select Yes/NO of counter clear with 10-key.
YES: Clear
NO: Not clear
4) Press [START] key.
* = MAINTENANCE
Operation/Procedure
1) Select the counter to be cleared with 10-key.
2) Press [START] key.
The confirmation to clear is opened.
3) Select Yes/NO of counter clear with 10-key.
YES: Clear
NO: Not clear
4) Press [START] key.
* = DV CARTRIDGE
Operation/Procedure
1) Select the counter to be cleared with 10-key.
2) Press [START] key.
The confirmation to clear is opened.
3) Select Yes/NO of counter clear with 10-key.
YES: Clear
NO: Not clear
4) Press [START] key.
24-3
Purpose Data clear
Function
(Purpose)
Used to clear the number of use of the finisher,
SPF, and the scan (reading) unit.
Section
Item Counter
1 SPF SPF paper pass quantity
2 SCAN Number of times of document scan
3 STAPLER Number of times of stapling
4 PUNCH Number of times of punching
5 STAMP Number of times of SPF finish stamp
Press [START] key. Press [SYSTEM SETTINGS] key or
[START] key.
24-4
Purpose Data clear
Function
(Purpose)
Used to reset the maintenance counter.
Item Counter
1 MAINTENANCE Maintenance counter
SIMULATION 24-3
ORG./STAPLE COUNTER DATA CLEAR. SELECT 1-5, AND PRESS
START.
1. SPF
2. SCAN
3. STAPLER
4. PUNCH
5. STAMP
1
SIMULATION 24-3
* COUNTER DATA CLEAR.
ARE YOU SURE?
1. YES
2. NO
1
Press [START] key. Press [SYSTEM SETTINGS] key or [START] key.
24-5
Purpose Data clear
Function
(Purpose)
Used to reset the developer counter. (The
developer counter of the DV unit which is installed
is reset.)
Section Image process (Photoconductor/Developing/
Transfer/Cleaning)
Item Counter Developer
1 DV CARTRIDGE Developer cartridge
Press [START] key. Press [SYSTEM SETTINGS] key or [START] key.
24-6
Purpose Data clear
Function
(Purpose)
Used to reset the copy counter.
Item Counter Copy
SIMULATION 24-4
MAINTENANCE COUNTER DATA CLEAR. PRESS START.
1. MAINTENANCE
1
SIMULATION 24-4
* COUNTER DATA CLEAR.
ARE YOU SURE?
1. YES
2. NO
1
SIMULATION 24-5
DEVELOPER COUNTER DATA CLEAR. PRESS START.
1. DV CARTRIDGE
1
SIMULATION 24-5
* COUNTER DATA CLEAR.
ARE YOU SURE?
1. YES
2. NO
1