Sharp UX-1300

OPTIONAL SETTINGS
Setting 3: RECALL INTERVAL
This sets the amount of time your fax will wait between automatic redials when the
line is busy. Enter "01" for 1 minute, "02" for 2 minutes, etc., up to a maximum of 15
minutes.
e Factory setting: "05"
Setting 4: RECALL TIMES
This sets the maximum number of times your fax will automatically redial if the line
is busy. Enter any number from "00" to "15".
e Factory setting: "02"
Setting 5: TEL/FAX REMOTE NUMBER
This sets the 1-digit number for activating fax reception from an extension
telephone. Enter any number from "0" to "9".
e Factory setting: "5"
Setting 6: REMOTE RECEPTION SELECT
This turns detection of the code for activating fax reception from an extension
phone on or off. Press "1" to turn detection on, or "2" to turn detection off.
e Factory setting: "1"
Setting 7: TRANSACTION REPORT PRINT SELECT
This sets the condition for printing out a Transaction Report. Enter a number from
"1" to "5" as follows:
"4" (ALWAYS PRINT): Print out after each transmission, reception, or error.
"2" (ERR/TIMER/MEM): Print out after an error, timer operation, or memory
operation.
"3" (SEND ONLY): Print out only after a transmission.
"4" (NEVER PRINT): Never print out.
"5" (ERROR ONLY): Print out only after an error occurs.
e Factory setting: "5"
Setting 8: DIAL MODE
This sets the mode of dialing. Press "1" if you are on a touch-tone line, or "2" if you
are on a pulse dial line. (If you don’t know which type of line you have, try making
phone calls with both settings and see which one works.)
e Factory setting: "1"
8-2 OPTIONAL SETTINGS