Sharp UX-1300 User Manual

SENDING DOCUMENTS
| Mor-Vol lave Mm tal-mecerersiitccielt
Up to 20 pages can be placed in the feeder at one time. The pages will be
automatically fed into the fax starting from the page on the bottom.
¢ If you need to send or copy more than 20 pages, place the additional pages
gently and carefully in the feeder just before the last page is scanned. Do not try
to force them in, as this may cause double-feeding or jamming.
¢ If your document consists of several large or thick pages which must be loaded
one at a time, insert each page into the feeder as the previous page is being
scanned. Insert gently to prevent double-feeding.
Adjust the document guides to the width
of your document.
Place the document face down and push
it gently into the document feeder. The
top edge of the document should enter
the fax first.
e The feeder will draw the leading edge
of the document into the fax. READY
TO SEND will appear in the display.
3 You can now either make resolution
and/or contrast settings as described in
the following section, or dial the other
party as described in the section, "Dialing
and transmission".
Important:
If you need to remove the document from the feeder before transmission or copying,
first open the operation panel by pulling the front edge up (grasp it at the "PANEL
RELEASE" mark), and then remove the document. If you try to pull the document out
without opening the operation panel, you may damage the feeder mechanism.
3-2 FAX OPERATIONS

Sharp UX-1300 Specifications

General

Brand	Sharp
Model	UX-1300
Category	Fax Machine
Language	English