Sharp UX-1300 User Manual

PROBLEMS AND SOLUTIONS
The power is on, but no
transmission takes place.
The power is on, but no reception
takes place.
The printing paper does not come
out.
The printing paper comes out blank
when you try to receive a document.
The received document is faint.
Received images are distorted.
Make sure that the receiving machine
has printing paper.
Make sure that the telephone line cord is
plugged into the "TEL. LINE" jack, and
not the "TEL. SET" jack.
If the receiving machine is in manual
mode with no attendant, reception will
not be possible.
If the receiving machine is not a Sharp
model, make sure it is G3 compatible.
Check the display for error messages.
Pick up the handset and check for a dial
tone.
Make sure that the telephone line cord is
plugged into the "TEL. LINE" jack, and
not the "TEL. SET" jack.
The printing paper may be jammed. See
"Clearing Jammed Printing Paper" in this
chapter.
Make sure that the printing paper is
properly loaded in your machine.
Make sure the power is on.
Make sure that the document is loaded
properly in the feeder of the transmitting
machine. Make a copy to confirm the
printing ability of your machine.
Ask the other party to send higher
contrast documents. If the contrast is still
too low, your fax may have a problem.
Make a copy to check it.
Noise on the telephone line may cause
distortion. Have the other party try
sending the document again.
Make a copy of another document on
your fax. If the copy is also distorted,
your fax may have a problem.
11-2 TROUBLESHOOTING

Sharp UX-1300 Specifications

General

Brand	Sharp
Model	UX-1300
Category	Fax Machine
Language	English